You
have purchased your fog or driving lights and wiring kit and have mounted these
lights to your rig.
Now you must run the
wire and mount the relay and switch so you can get the
fog or driving lights lit
up. You will need to read the installation instructions
provided with your wiring kit in order to hook these
fog and or driving lights up
properly. Do this before you open the package and again
after opening the wiring kit while viewing the parts that are
included in the wire kit package.
Most Wiring Kits provide
wire, relays, fuses and a switch. These are all essential for the
proper installation of your driving or fog lights. Some installations do not
require a separate switch and some do. Here is an example of a
typical wiring kit.
Notice that this kit
includes the Wire with a fuse holder a relay, a switch and some
wire ties to make your installation look like it was professionally
done. This wiring kit has the instructions on the back of the package
and you should cut the plastic on the front of the package to remove
the contents in order not to destroy the instructions before
installation.
Click the
picture to purchase a wiring harness from us.
These wire kits
typically cost between $20.00 and $40.00 depending on whether the
kit is a light duty kit (2 - 55W lights) or a heavy duty kit (2
-55W/150W lights) like the ones we sell with both
our FOG
and DRIVING
lights. Remember to purchase a wire kit that has heavy
enough wire that will handle
the amount of amps that your driving or fog lights will be drawing.
Here is a wiring diagram for a 2
light set up without a relay.
Here is a wiring diagram for a 2
light set up with a relay.
